东莞映荣精密机械厂
产品分类
钻孔攻牙多功能复合机
伺服钻孔、攻牙多功能一体机
伺服牙杆式精密自动攻牙机
伺服精密自动钻床
自动攻牙机
多轴器
多轴器配件
联系方式
电话:0769-83691258
传真:0769-83691259
手机:13602395358
邮箱:ydh@dgyingrong.com
在线咨询:点击这里给我发消息    
映荣诚信通
产品展示
首页 > 产品展示 > 多轴器 >
U型圆形多轴器

U型圆形多轴器

产品描述:

本体结构利用齿轮箱配合万向节头所组成,容易调整加工孔距不受齿轮所限制,节省调整的时间,也少有死角的限制,适合加工接近圆周分布孔的工作,是可调式中最容易操作使用的规格。为保万向节头之寿命,移动范围不得超过15度,等于垂直之前后左右30mm以内。(尽量配合工作之孔距坐标,设计齿轮箱结构即定镗孔位)


The basic frame consists of gear case and cardan joint. The hole-distance is easy to control and will not be affected by the gears. The set up time is thus saved and it is mostly free of dead angles. It is very suitable for working of round holes and is the easiest to operate among the adjustable type. Toensure the lifetime of the cardan joint, the moving range should be confined within 15 degrees, which means within a distance of 30mm to the vertical status. (When designing the structure of the gear case of the gear case or the position of the bore, try to build the coordinate per working hole.)


万向节注意事项:
1、调整时不能超过规定的角度15度。
2、如超过此极限心轴易磨损或断裂。
3、工作时应经常加润滑油脂。


Note of cardan joint:
1. DO not set the angle to more than the specified 15 degrees.
2. If the limit is exceeded, the shaft will be easy to wear or break.
3. During work, lubrication should be added frequently.

返回上一页
东莞市映荣精密机械厂  版权所有    粤ICP证10224628号  技术支持:神州通达网络
电话:0769-83691258    传真:0769-83691259    手机:13602395358   邮箱:ydh@dgyingrong.com 网站地图
厂址:东莞市东坑镇东兴西路315-317号   东莞市映荣精密机械厂 -专业攻牙机厂家,钻孔机、多轴器自动攻牙机自动钻孔机供应商!